id: 3.1-separation title: 3.1 Separation meta: Separation rules when operating a tower facility within Infinite Flight. order: 1 #
3.1 Separation #
The same separation should be afforded in these scenarios to protect for missed approaches/go arounds.
3.1.1 #
The table below outlines the separation requirements that must{.red} be applied to ALL aircraft:
Type | Rule |
---|---|
Departure / Departure | The first aircraft must{.red} be airborne before the second aircraft* commences the take-off roll |
Arrival / Arrival | The first aircraft must{.red} be clear of the runway edge (not the hold short line) before the second aircraft crosses the threshold |
Departure / Arrival | The first aircraft must{.red} be airborne before the second aircraft crosses the threshold |
Arrival / Departure | The first aircraft must{.red} be clear of the runway edge (not the hold short line) before the second aircraft commences the take-off roll |
Intersecting | Arriving/departing aircraft must{.red} be beyond the runway intersection prior to a departure beginning it’s take-off roll or an arrival crossing the threshold on an intersecting runway. Consideration should{.red} also be given to the extended centerline of runways, where the runway does not physically intersect, but aircraft flight paths would during take-off and landing. In these cases the same separation criteria should{.red} be afforded |
*In addition, aircraft type should{.red} be taken into account, e.g. if the first aircraft to depart is a Cessna 172, and the second aircraft is a Boeing 737; it is likely the 737 will catch up with the C172 very quickly if minimum separation rules are applied, therefore time should{.red} be added before the second departure to allow for this
3.1.2 #
Anticipation is encouraged and should{.red} be used when appropriate, for example if a Boeing 737 has already been cleared for take-off and is rolling, rather than issuing a LUAW clearance to the next aircraft, ask yourself if issuing a take-off clearance is appropriate based on the assumption that the first aircraft will be airborne by the time the second aircraft is ready to roll (see 3.2.3 below).
3.1.3 #
If at any time, separation is likely to be lost, the Controller must{.red} be proactive. This is particularly important with a Departure / Arrival sequence, the arrival can be sent around but consideration should{.red} also be made as to whether or not the departure should have its “take-off clearance cancelled” to prevent the departing traffic climbing into the traffic that is initiating the missed approach (see 3.5.4 below).
3.1.4 #
Most commercial aircraft approach speeds are between 120-150kts. If a Controller needs more separation the use of “maintain slowest practical speed” can be utilized, however this should not{.red} be used within 4 miles to touchdown as it is likely the aircraft is already at its final approach speed. In addition, the Controller should{.red} also look at the groundspeed (GS)/indicated airspeed (IAS) of the aircraft in question before sending this command as the aircraft could already be at their final approach speed. Regardless of aircraft position, if an aircraft IAS is excessive then this command can be useful however it is important to take note of two points:
- if the aircraft is close in, it may already be too late and a go-around might be the only option left
- try to avoid slowing aircraft down too far out if you have a Radar Controller present as they may have a line of aircraft on approach and it could have a detrimental effect to their spacing (if you need more space and a Radar Controller is present, tell them - see 3.6.1 below)